Leveling up my brassica bed.

in Build-It3 years ago

Greetings, all you glorious gardeners and gleeful gawkers! For this post, I'll be talking about some of the challenges of gardening on a slope, and showing off a project I'm working on to make one of my gardens a bit easier to deal with. I'm trying to take advantage of a rainy day to get several posts scheduled, so I'll skip most of the introductory filler words and get right to it.

Gardening on too steep of a slope is a constant battle against gravity. Water, nutrients, soil, and sometimes even plants will always be moving from the uphill side to the downhill side. While watching all these movements take place can be fascinating, the extra variables make it difficult to manage a consistent garden. Ideally, I would rent or borrow a mini excavator to make short work of flattening this space off, but I currently don't have a path to this garden that is excavator accessible.

If you've been following since last spring, you may recognize this garden as the one I had a hard time keeping the woodchuck from. When I first put this garden here, it was the flattest, clearest space I had with more than 2" of dirt. The large piece of plastic covering the garden has helped keep the soil in place over the years, but now that I've cleared enough space around it, it's time to expand this garden and level the whole thing up a bit. On the right hand side of the picture below, you can just barely see the white paint marking the new lower border, which ends at the gas can.

20210311_151457.jpg

You can see that last year's Brussel's sprouts are still hanging in there, and I'm hoping to save one or two of these to get seeds from. The paint marking the upper edge and far side is easier to see in this picture, and the lower corner is marked by the stake near the gas can. I haven't actually measured it, but I'll be roughly doubling the size of this garden this year.

20210311_151213.jpg

There isn't much to harvest on the Brussel's sprouts, but I'll get what I can before I have to dig them up.

20210311_150929.jpg

Just getting all the fence taken down and the plastic pulled up took a whole day. The plastic was held down by about 2 dozen 10" ground spikes, and the fence all had dead weeds tangled in it. The whole area was also littered with leftover plant tags, cells, and other debris left behind from last year's gardening.

20210311_160437.jpg

Once the old fence was removed, I pulled the old T-posts and drove them in along the line of the new lower border. The posts will hold these aspen logs in place for a retaining wall. There is currently about 3 feet of drop from the upper end to the lower end, I want to take about a foot from the upper side and move that to lower side, which will cut the slope down to just 1 foot of drop.

20210311_164754.jpg

For the near side, I have these old cedar logs that I cut down about 5 years ago. Cedar is very rot resistant, and I wish I had enough of it to frame the entire garden. I'll border the lower end of the garden with perennials that have strong root systems, so by the time the aspen rots away, there should be a plant wall holding the soil in place.

20210311_165252.jpg

The cedars fit together fairly nicely, but the aspen needed some more long branches brought in to help fill in the gaps. Another wooden stake had to be driven in at the corner to help hold the ends of some of these new pieces.

20210311_165945.jpg

As I begin digging the upper side, I place the larger rocks I find at the base of my log wall, on the inside. This helps further close the holes, fill in space in the deepest parts, and will help keep things in place after the aspen logs rot away.

20210312_095525.jpg

Wherever there is sod to remove, I take that first and use it to continue filling holes in my logs. Once the gaps are filled well enough, I try to fill in all but the top 6 inches of the low side with compostable material. For this project, it was mostly weeds and branches, along with a few old logs that were too rotted to burn. By filling with biodegradable material instead of just more rock and clay, my soil should continue to improve for the next several years.

20210414_143422.jpg

One slow wheelbarrow full at a time, the garden begins to transform. As I dig, I first spread the topsoil in the shallower spots that only need 1-3 inches added. Once I've dug far enough to hit clay, I dump the clay in with the biodegradable fill, and other deeper spots. I save my best topsoil for spreading on top, keeping some aside to cover back over the areas where I've dug down to the clay.

20210414_162204.jpg

From the looks of the weather forecast, I still won't quite be done with this project before it posts, but you will definitely get to see plenty of the finished garden in the coming season! As you can see, just filling in the bottom reduced the slope of this garden quite a bit. I'm eager to try some carrots and parsnips in this new super-deep end of the garden!

20210414_162213.jpg

Hopefully, I can do a sequel to this post in a week or two that will not only show the completed garden, but also the planting of several cold-hardy vegetables that have been waiting patiently for me to finish their new home. Give me a follow if you don't want to miss it, I hope to see you then!

Sort:  

You seem to be using older or Legacy version of Ecency!
Please install newest version to get most out of Ecency, Install Android: https://android.ecency.com, iOS: https://ios.ecency.com mobile app or desktop app for Windows, Mac, Linux: https://desktop.ecency.com
Learn more: https://ecency.com
Join our discord: https://discord.me/ecency

3.0.16 has some wallet bugs, and I'm currently considering rolling back my desktop installs to 3.0.15. Are there any security reasons why I shouldn't do this?

You are right, wallet bug is fixed we will push update soon. Meanwhile you can just change filter in transaction history and it will start working. Always good to use latest version, but if you are ok without new features you can downgrade until next release, up to you.

Yes, I found that workaround for the Ecency wallet very early, but haven't found a way to load the history on my Hive wallet. Is there an easy workaround for that as well?

You could try https://ecency.com that works or wait for next release of desktop app for now.

Hi paradoxtma,

This post has been upvoted by the Curie community curation project and associated vote trail as exceptional content (human curated and reviewed). Have a great day :)

Visit curiehive.com or join the Curie Discord community to learn more.

Congratulations @paradoxtma! You have completed the following achievement on the Hive blockchain and have been rewarded with new badge(s) :

You received more than 8000 upvotes.
Your next target is to reach 9000 upvotes.

You can view your badges on your board and compare yourself to others in the Ranking
If you no longer want to receive notifications, reply to this comment with the word STOP

Check out the last post from @hivebuzz:

Hive Tour Update - Governance
Support the HiveBuzz project. Vote for our proposal!

What a project! Makes my efforts look puny! I loved seeing the progression from the start. I do hope you manage a sequel...

Ha, I don't think I have enough land here to make your efforts look puny! I'm pretty sure the sequel post will happen, if not I'll take about it some more in the other inevitable posts that will come along when I get that bed planted.