#restorationUnmoderated tagAll postsTrending CommunitiesLeoFinancePinmapplePhotography LoversVibesHIVE CN 中文社区SplinterlandsActifitLiketuHive LearnersHive SucreHive GamingBlack And WhiteExplore Communities...#restorationTrendingHotNewPayoutsMutedshaunmza (62)in Build-It • 16 hours agoA lot of work for little visual differenceNot an lot of change visually but I did spent quite some time welding in thin strips to replace the rusted edges that I had cut off / back to get to clean metal. This is just…shaunmza (62)in Build-It • 3 days agoPeeling away another layer to find even more rustI tried cutting away the least amount of metal, so that replacing it would be somewhat simple, unfortunately I found more rust after I cut the first piece out, so I cut some more…shaunmza (62)in Build-It • 4 days agoCutting out some a portion of the windshield cowl and inspecting the insideIt took a while but I finally managed to gather up the courage to cut a large hole in what, on the surface, looks to be good steel. It's actually not as bad as I expected but I…shaunmza (62)in Build-It • 2 days agoStarting to patch up the rust under the windscreenCutting out rust from the inner layer meant I could now see through and into the cab... I chased down the last bit of rust into the engine bay as well and made up a tiny sliver…valentinalife (70)in Team Ukraine • 7 days agoЗламані плани, втрачені ресурси: хто винен?Дуже важко було зібрати докупи всі необхідні лікарські процедури, що маю пройти на цьому тижні. Все, що вдалося зробити за місцем проживання, - зроблено. Але три пункти із списку…shaunmza (62)in Build-It • 5 days agoCutting out a small part of the windshield cowlIt was quite obvious that there was rust on the edge of the windshield, so I cut out a small section to see what I might have to deal with. After a lot of procrastination I cut…shaunmza (62)in Build-It • 6 days agoRust, rust and rustThe more I scratch the more rust I find, there is nothing to do but to cut it out. This time it is right at the top of the drivers side door pillar by the upper door hinge…shaunmza (62)in Build-It • 7 days agoShaping metal to fit the cut out from below the windshieldUsing the template made from masking tape before, I cut out a piece of metal plat and tried to figure out how to get it to fit the shape, it's not obvious from the photos but…