You are viewing a single comment's thread from:

RE: Part Cooling in 3D Printing

in #diy6 years ago

Print speed is very important.
It makes a big difference especially for the outer perimeter to let it cool down more for steep overhangs.
The time per slice can help a lot on the speed corner: 15 seconds is a good value to start with.

Sort:  

You are absolutely right! Although 15 seconds seems to be a bit extreme. 5 seconds per layer seem to work fine for me...

I know it seems a lot but with 15 seconds it works for nearly any geometry: including small miniatures and also high throughput printing with 0.8mm nozzle.