Name and function of motorcycle carburetor components

Name and function of motorcycle carburetor components

The carburetor is one part of a motorized vehicle engine such as a motorbike or car. It can be said that the performance of the carburetor on a motorcycle is likened to vehicle ammunition. Without the carburetor on the vehicle, the vehicle cannot work as its function. Therefore, the carburetor component should always be properly maintained so that it can work as it functions.

This is the name and function of the motorcycle carburetor component.

Venturi: air inlet located in the center of the carburetor unit with a diameter according to cc capacity, motorcycle engine and engine speed.
Pilot jet: the component that is located inside the carburetor, functions as a fuel spray from the lower rpm to the middle.
Main jet: the component located inside the carburetor, functions as a fuel spray from the middle rpm to the top rpm.
Float chamber: carburetor bowl, functions as a temporary fuel storage before reckoning in the combustion chamber.
Piston skep: function to regulate the air to enter the combustion chamber.
Skep needle: its function is to regulate the flow of fuel through the shape of the tip of the needle.
straight jet holder: function for main jet position
Needle jet: its function is to regulate the amount of air and fuel passed between the gap of the jet needle jet and the needle jet.
Buoy: its function regulates the flow of fuel entering the gasoline bowl.
Float valve: its function is to regulate gasoline into the bowl.
Fuel valve: its function is to adjust not and close the fuel inlet from the gasoline carburetor tank.
Float pin: function as a locking position of the float so that it can rise and fall.
Air settings: its function is to set air how much into the combustion chamber.
Throttle stop screw: its function is to adjust the ideal slope.
Spring: function to restore throttle. Valve is the original position after being pulled by the gas cable.
Retainer: its function is to lock the jet needle and need to sketch on the throttle valvr or the needle skep.
O ring: function to seal each component in the carburetor so that no leakage occurs.
Vacuum and per rubber: its function is to regulate how much fuel and air enter the combustion chamber to work.

*** That is the name and function of the components in the motorcycle carburetor according to my knowledge and hopefully it can benefit you all (thank you)***