You set the limit for each gate. Use the buttons on the control board to fine tune where they are to stop when closed then press the set limit button and it closes to the same point each time.
You are viewing a single comment's thread from:
You set the limit for each gate. Use the buttons on the control board to fine tune where they are to stop when closed then press the set limit button and it closes to the same point each time.
Sounds like mighty Mule gate limits are pretty consistent!!👍😀
With a single gate it always stops in the correct position after I set the limit, I was just wondering if two gates would still be consistent sounds like they are!!👍😀