Then just today, i have a couple injectors not firing... after a couple hours of ohm-ing out a 42pin wiring harnesses and my 30 pin injector drive module.... I am pretty sure I found the issue.... a sub-par under the valve cover wiring harness that I put in 4 years ago. I didn't know that it wasn't recommended until after the fact... oh well better now than when I have my family and camp trailer bombing down the highway. Lol.
You are viewing a single comment's thread from:
At least you found the problem. I wouldn’t even know where to start.
Honestly I went into panic mode for about 20 minutes. Then I had to gather myself and say, “Better now than in the middle of the woods”