Good evening friend of this Hive today I want to share with you the craft of a girl's bow which was made with frosted foami.
Materiales
- foamia escarchado
- silicon caliente
- un cayó de pelo
Materials
- frosted foamia
- hot silicon
- one hair fell
Procedimiento
Tomamos un cuadrado de 12 cm aproximadamente y hacemos un patrón de las siguientes maneras doblamos el cuadrado en dos y de orilla a orilla partiendo de la punta hacemos medio círculo y cortamos hacia adentro hasta llegar a la otra punta lo abrimos y así quedará formado nuestro lazo luego lo cortamos en el foami y pegamos las dos punta hacia el medio, luego cortamos una cinta pequeña que va al centro de lazo y por último colocamos 2 cinta colgante con un corte en la punta Y pegamos el gancho del pelo y así quedará nuestra prenda lista
Procedure
We take a square of 12 cm approximately and we make a pattern in the following ways we fold the square in two and from edge to edge starting from the tip we make a half circle and cut inwards until we reach the other end we open it and this way our bow will be formed then we cut it in the foami and we glue the two tips towards the middle, then we cut a small ribbon that goes to the center of the bow and finally we place 2 hanging ribbon with a cut in the tip and we glue the hair clip and this way our garment will be ready.
Translated with www.DeepL.com/Translator (free version)
Esto fue mi experiencia del día de hoy para todas las mama que lo puedan realizar para las consentidas de la casa nos vemos hasta un nuevo post Dios le bendiga
This was my experience today for all the moms that can make it for the spoiled of the house see you until a new post God bless you.
Congratulations @sorirene! You have completed the following achievement on the Hive blockchain and have been rewarded with new badge(s) :
Your next target is to reach 40 posts.
You can view your badges on your board and compare yourself to others in the Ranking
If you no longer want to receive notifications, reply to this comment with the word
STOPTo support your work, I also upvoted your post!
Check out the last post from @hivebuzz: