Hello, dear readers
It’s finally going on its way! Today, I picked up the main piece of the neck and after some hours of sharpening my plane’s blade, I started to do some work.
Buen día, estimados lectores.
¡Ya comenzó el proyecto! Hoy, luego de varias horas afilando la hoja del cepillo, tomé la pieza principal del mástil y comencé a trabajar.
What I did today was basically remove the marks that were on the wood. These were made when the pieces were cut with a table saw. Also, this is the moment in which you need to make the piece even on each side. As you can see, I needed to keep a minimum width at 18 millimeters. This is to ensure the neck has the strength needed to prevent it from bending or breaking.
El trabajo de hoy fue básicamente remover las marcas de la madera. La madera que ha sido cortada para cualquier propósito suele retener marcas hechas por la sierra. Además, emparejé los lados del mástil. Como pueden ver en una foto, se necesita mantener un mínimo de 18 milímetros de espesor en esta pieza. Esto asegura que no se doble o rompa.
That is all for this entry. Thanks a lot for reading. See you in the next chapter.
Eso es todo por esta ocasión. Gracias por leer. Nos vemos en el próximo post.
All the pictures used in these post were taken with my phone.
Todas las fotos en este post fueron tomadas con mi teléfono.
Congratulations @bertrayo! You have completed the following achievement on the Hive blockchain and have been rewarded with new badge(s) :
You can view your badges on your board and compare yourself to others in the Ranking
If you no longer want to receive notifications, reply to this comment with the word
STOP
Do not miss the last post from @hivebuzz: